Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Futakawa, Masatoshi; Naoe, Takashi*; Kogawa, Hiroyuki; Ikeda, Yujiro
Journal of Nuclear Science and Technology, 41(11), p.1059 - 1064, 2004/11
Times Cited Count：12 Percentile：61.53(Nuclear Science & Technology)High power spallation targets for neutron sources are developing in the world. Mercury target will be installed at the material and life science facility in J-PARC, which will promote innovative science. The mercury target is subject to the pressure wave caused by the proton bombarding mercury. The pressure wave propagation induces the cavitation in mercury that imposes localized impact damage on the target vessel. The impact erosion is a critical issue to decide the lifetime of the target. The electric Magnetic Impact Testing Machine, MIMTM, was developed to produce the localized impact erosion damage and evaluate the damage formation. Acoustic vibration measurement was carried out to investigate the correlation between damage and acoustic vibration. It was confirmed that the acoustic vibration is useful to predict the damage due to the localized impact erosion and to diagnose the structural integrity.
Meigo, Shinichiro; Harada, Masahide; Teraoku, Takuji*; Maekawa, Fujio
Proceedings of ICANS-XVI, Volume 3, p.1175 - 1180, 2003/07
It is important to monitor the proton beam for the high intensity pulse spallation target. Especially for the beam halo, which may irradiate the bulk surrounding the target, it is important to be observed to prevent causing heat spot in the shielding bulk. At JSNS, a proton beam monitors are located at front of the target. These monitors are assembled with the proton beam window. Since this scheme increases the radiation on the monitor due to the beam loss at the windows, it may arise heat deposition on the monitor. Therefore, heat deposition is calculated with NMTC/JAM. It is found that the heat deposition for normal operation is less than 0.1 W/cc.
Futakawa, Masatoshi; Kogawa, Hiroyuki; Tsai, C.-C.*; Ishikura, Shuichi*; Ikeda, Yujiro
JAERI-Research 2003-005, 70 Pages, 2003/03
JAERI-Research-2003-005.pdf:12.08MB
A liquid-mercury target system for the MW-scale target is being developed in the world. The moment the proton beams bombard the target, stress waves will be imposed on the beam window and pressure waves will be generated in the mercury by the thermally shocked heat deposition. Provided that the negative pressure generates through its propagation in the mercury target and causes cavitation in the mercury, there is the possibility for the cavitation bubbles collapse to form pits on the interface between the mercury and the target vessel wall. In order to estimate the cavitation erosion damage due to pitting, two types of off-line tests were performed: Split Hopkinson Pressure Bar (SHPB), and Magnetic IMpact Testing Machine (MIMTM). The data on the pitting damage at the high cycle impacts up to 10 million were given by the MIMTM. As a result, it is confirmed that the mean depth erosion is predictable using a homologous line in the steady state with mass loss independently of testing machines and the incubation period is very dependent on materials and imposed pressures.
*; *; *; Yagi, Toshiaki; Seguchi, Tadao
Proc. on the Electrical Electronics Insulation Conf. and Electrical Manufacturing & Coil Winding Conf., p.703 - 706, 1993/00
no abstracts in English
; ; *; *; *
Bulletin of the Chemical Society of Japan, 41(5), p.1261 - 1263, 1968/00
Times Cited Count：7no abstracts in English
